Install a Snowflake Ice Machine in 3 Steps

2022-06-27 09:48:09

It takes three steps to put an elephant in the refrigerator, but how many more steps does it take to install a snowflake ice maker?

Snowflake ice machine was selected by the laboratory because it can make granular ice. However, the premise of using it is to install the machine so that it can produce ice smoothly and efficiently. How to install it? Snowflake ice machine manufacturer – Tianchi tells you that you can install a snowflake ice machine in three steps.

1.After arrival

Normal logistics will deliver machine products such as snowflake ice maker upright to your hands. After you get it, keep the ice maker in this upright state, don’t tilt it, slowly remove the wooden box, and you will have a brand new snowflake ice maker.

2.When installing

If conditions permit, or when the local water quality is not good, a filter can be installed at the water inlet of the snowflake ice maker for water purification, because the cleaner the water in the ice maker, the longer its life. This is conducive to subsequent machine cleaning. After all, it is not easy to remove scale, and it always blocks the pipeline.

Then, connect the ice maker to the water inlet and outlet pipes, which are all in the piping machine, plug in the power supply, turn on the switch, and it can be put into use.

3.The installation is completed

If you don’t have to use it in a hurry, you can let the snowflake ice machine “stand” quietly for 24 hours or 48 hours, and then connect to the power supply for use. On the one hand, it is to allow the refrigerant to flow back, after all, there is no guarantee that there will be no bumps during transportation, causing the refrigerant to “run around”; on the other hand, it is also good for the compressor.

Isn’t it very easy to install a snowflake ice maker in just three steps!

Install a Snowflake Ice Machine in 3 Steps